Asko T761 Bedienungsanleitung PDF herunterladen (Seite 3)

Page 3

ENGLISH

Your new energy-efficient ASKO dryer is designed to

give you maximum drying performance using less

energy. To make the most of the dryer’s functions and

features, we recommend that you read this manual

carefully before using your machine for the first time.

For operating instructions, refer to the section in this

guide for your specific model.

Below is an illustration of the parts and features of your

ASKO dryer.

ASKO DRYER FEATURES

Power

Button

Lint Filter

Condenser Unit

(behind panel)

(T721 & T781 only)

Lint Filter

Holder

Cleanable Fan

(behind panel)

Type Plate

(Type and Serial Number)

DRYING SYSTEMS

ASKO dryers come with three different drying systems:

Sensidry

Models T731, T761 and T781 have our state-of-the-art

Sensidry system. These machines are equipped with a

humidity sensor that ensures different fabrics always

dry thoroughly. This sensor turns off the heat when the

laundry has reached the appropriate dryness.

Thermostat-Control

Model T701 has a thermostat that controls the

temperature by turning the heating element on and off

to maintain the selected drying temperature (Normal or

Low) within +/- 5° F.

Timer-Control

Model T701 has timer-controlled drying in addition to

the two automatic (thermostat-controlled) programs.

Model T721 offers only timed drying. You can set the

dryer to run from 30 minutes to 190 minutes.

ENERGY SAVING TIPS

♦ Dry like fabrics together (i.e., heavy fabrics together,

light fabrics together).

♦ Clean the lint filter after each load.

♦ Do not over-dry clothes when using the timed program.

♦ Spin the clothes at no less than 800 rpm.

♦ Dry consecutive loads to avoid reheating the dryer.

♦ Do not overload the dryer.

♦ Use the highest spin speeds allowed for the

garments.

♦ Do not put extremely wet clothes into the dryer.

Model T731 has timer-controlled drying in addition to

the four automatic programs.

When using a timed drying program, be careful not to

dry the clothes too long. It’s best to use a shorter time;

then if the load isn’t dry, you can set the timer for a few

more minutes.

OVERHEAT PROTECTION

ASKO dryers are designed with an overheat protection

switch that automatically turns off the machine if the

temperature is too high. The machine will not start until

it has cooled sufficiently.

The dryer could overheat if the lint filter or exhaust hose

becomes clogged with dust. It’s a good idea to make

sure the lint filter, exhaust hose and vent duct are clean

before you call for service. If you use dryer sheets (not

recommended), you may need to wash the lint filter with

warm water and a soft brush to clean any blocked holes.

If you have a condenser dryer (T721 or T781), first make

sure the condensation water container is empty (see

page 22).

If the overheat protection switch is activated, you have

to reset it before the machine will run. To do this, press

the reset button (rubber disk) on the back of the machine,

as illustrated below. You should hear a click when it

engages. The machine cannot be reset until it has cooled

sufficiently.

NOTE: If your dryer overheats frequently, it may not be

vented properly or the room in which it is located

may not have sufficient air circulation. Contact

your installer to have these issues checked out.

COOL-DOWN

Every program on an ASKO dryer ends with a cool-

down cycle to reduce wrinkling. Unlike with other dryers,

the laundry will feel cool when you remove them from

an ASKO dryer. No more scorched fingertips.

Condensed Water

Container

(T721 & T781 only)

Control

Panel

Press the reset button

to start the machine.

1 2 3 4 5 6 7 8 ... 25 26

Kommentare zu diesen Handbüchern

Keine Kommentare

Asko T761 Bedienungsanleitung Seite 3

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Trockner Asko T761